Corsair 4000D Attachable Rear Feet

[EDott]

Hi all.

I recently purchased a new PC with the 4000D Corsair Airflow tower. I have no idea how to attach / screw on the rear feet, and the guide is useless. Please see attachments below (PC, Feet, and "guide").

This could be me being stupid, but I the screws don't even properly fit in the feet, and they don't reach the top of the feet. Any help?

Thanks all.

 

[Scott]

Are the front ones already attached? How are they attached.

With the PC specialist info, do you know what the rectangular PCS plate refers to?

From the way you are holding it, they look upside down? I think they should be angled side down and the screw should go into the foot from inside the case.

 

[TonyCarter]

The hole in the foot with the rubber pad is what sits on the desk, and you should find another hole inside to screw through into the case...although mine came pre-installed.

They side width-wise, rather than length-wise though, s maybe that's want stopping them fitting or lining up properly..

 

[EDott]

Hi Scott and Tony,

I got this sorted; it was mostly me being stupid. When I slid the screws down the hole in the foot they didn't appear on the other side. Turns out they were just getting stuck and I have to give it a wiggle for the screw to slide all the way down!

Thank you for your replies.

 

[DanielMarshall86]

Really glad this was here. The photo made me realise where I was going wrong, many thanks.

The hole in the foot with the rubber pad is what sits on the desk, and you should find another hole inside to screw through into the case...although mine came pre-installed.

They side width-wise, rather than length-wise though, s maybe that's want stopping them fitting or lining up properly..